Copyright Filtrec Asia Pacific. All rights reserved
CP-CL SERIES

CP-CL filter elements are made in stainless steel with wire mesh
filter media. With this construction solution they can be used on all critical applications where high operating temperature and chemical compatibility are necessary.
pdf-pulsanteover-en.jpg
PBA SERIES

Specifically designed for application with high contamination or high viscosity fluids, more than 10.000 cPs. PBA filter bags are manufactured and tested according to the highest quality standards
to assure consistent performances.
pdf-pulsanteover-en.jpg
PPP SERIES

PPP filter elements are made with polypropylene or borosilicate microfiber glass media. A wide choice of filter ratings are available, they are normally used for both membrane cartridges pre-filtration
and final filtration on several industrial applications.
pdf-pulsanteover-en.jpg
PMA SERIES

PMA filter elements are traditionally used in industrial applications where easy solutions, easy availability and cheaper filtrations are necessary. A wide choice of filter ratings and media is available to satisfy every kind of application.
pdf-pulsanteover-en.jpg
PCN SERIES

PCN filter elements are made in nylon microfibres and are used in all applications where polypropylene can not be used for chemical compatibility or low resistance with temperature problems.
pdf-pulsanteover-en.jpg
PCH SERIES

PCH filter elements are made with melt-blown process technology; these elements have a graded density matrix in polypropylene to enhance dirt holding capacity. They are specifically designed for high flow rate filtration, due to the typical low pressure drop of melt-blown cartridges.
pdf-pulsanteover-en.jpg
INDUSTRIAL FILTER ELEMENTS
PCS SERIES

PCS filter cartridges are recommended for high temperature filtration (up to 420 C) or where high differential pressure or chemical compatibility are required. Due to their mechanical resistance these elements are specifically used where backwashing
is required.
pdf-pulsanteover-en.jpg
PCP SERIES

PCP filter elements are made with melt-blown process technology; these elements have a graded density matrix in polypropylene to enhance dirt holding capacity. The matrix is supported by an inner core to stand differential pressure and grant an high mechanical resistance.
pdf-pulsanteover-en.jpg
GAS AND AIR

Gas and air filter elements used in industrial filtration.



pdf-pulsanteover-en.jpg
Home
Cross Referance
News
Contact Us
About Us
Quality
Replacment Elements
Industrial Elements
Filter Elements
Pressure Filters
Return Filters
Suction Filters
Spin-on Filters
Industrial Filters
Filter Housings
Test Fittings
Accessories
Compressed Air Products
Products